Nitrous, Super Chargers, & Turbos - Garrett K26 turbo on D-series?

I have an Audi Garrett K26 off an 89' 200 Turbo Quattro. I can't find ANYwhere that has an HF or CX manifold adapter plate for a K26 (or even K24). Can anyone give me a site that has an adapter, or even a D-series K26 Turbo header, for a purchase?

I searched and read that it should match a T3 flanged manifold.

Measure the flange and here is some data...

T25 flange- Studs are 72*40mm... Outside dimensions are 92*62mm

T3 flange- Studs are 85*45mm.... Outside dimensions are 90*82mm

Those are the only ones I could find in a hurry, and I believe them to be accurate.

I searched and read that it should match a T3 flanged manifold.
Hm.. I really just gotta pull the dam thing off the car. But I think it takes, like, an hour or more to get a turbo off.

Hm.. I really just gotta pull the dam thing off the car. But I think it takes, like, an hour or more to get a turbo off.

Not even an hour, just unbolt it from the downpipe, exhaust manifold, and the turbos outlet to the charge piping.

u can make a custom one too

Not even an hour, just unbolt it from the downpipe, exhaust manifold, and the turbos outlet to the charge piping.

Ok, that's a bit more encouraging that I'm not going to be under that car forever. haha! Thanks for the advice :)

How much work/time would it take to make a custom K24/K26 Turbo adapter to HF mani? I have no idea now much drilling time that would take.