Help replacing Igniter and Ignition coil
#3
RE: Help replacing Igniter and Ignition coil
sweet thats what i thought. thank ya much. the only part im worried about is taking the screw off that holds the rotor cuz when i replaced the dist cap and rotor it was in there pretty good, i kinad stripped the screw[:@]
#8
RE: Help replacing Igniter and Ignition coil
you will have to turn the engine to get the screw on the very top and get into there with a drill and drill the head off and continue drilling to get it down to the shaft to pull the rotor off.
good luck.
good luck.
#9
RE: Help replacing Igniter and Ignition coil
it would be a lot easier to remove the distrubutor......3 ,12 mm bolts and a couple of connectors
assuming timing is correct , mark the distributor so you reinstall it at the same spot
assuming timing is correct , mark the distributor so you reinstall it at the same spot
Thread
Thread Starter
Forum
Replies
Last Post
sledneck82
Mechanical Problems & Technical Chat
6
12-05-2009 09:27 AM