Just trying to figure out which rebuild kit is the best one to get for this type of engine and also what bore size, rod bearing, and main bearing size i should get.

 

That's actually more complicated than you think. You need to have the block checked out to make sure the cylinders are not out of round, then you can decide if you need to rebore the block and get oversized pistons. THEN you get the rings. You've also gotta have the crank measured to make sure you can still use stock size bearings.

I highly recommend downloading the service manual from hondatech.info: Honda service manuals to get more information on this.

 

ok thanks for the help