Need Info to make car go fast!
#41
07-06-2004, 02:36 PM
RE: Need Info to make car go fast!
go with a b16 or b18c1 they're great engines, reliable, and theres a lot u can do with em. ull be able to run 14's with slight mods...or u can just shove a **** load of nitrous into ur engine
#42
07-07-2004, 11:56 AM
RE: Need Info to make car go fast!
the h22 is a tight fit and dont even think about squeezing a turbo with it. go with the b16. its cheap and way easier.
#45
07-16-2004, 10:56 PM
RE: IMPORT KID's an Idiot
not doggin on the h22, but the b-series swap is too damn easy to even mess with the H swap. the biggest thing i can tell you is do all the little maintenance crap w/ the engine out of the car, replace the timing belt and water pump, the thermostat, the clutch. trust me.and check to make sure there is oil in the trans. oh and by the way, the b with a turbo weighs as much as an h
#46
08-08-2004, 02:33 PM
RE: Need Info to make car go fast!
i have a 1990 honda civic hatch with a JDM B16 DOHC VTEC that i am trying to get rid of because there is a hole in the block due to water being sucked in my intake. the head and 5spd trans have less then 50,000 miles and it is an easy fix. You could get a block from a junk yard for $150. the car is very fast and will spin the tires in 4th gear! REDLINE IS 9500 RPMS and will hit 120 in 4th like nothing.here are the mods...
-Fidanza lightweight flywheel
-Stage 3 ACT clutch
-AEM cam gears
-Aem fuel pressure regulator
-B&M short shifter
-Apexi AFC controller
-DC sports 1 piece header
-dc sports high flow cat
-2.5" custom exhaust w/ apexi bomb muffler
-auto meter pro-comp ultra lite VAC AND VOLTS guages(pilar pod)
-Tokico shocks
-skunk2 coilovers
-Freedom design front upper strut bar
-dc sports rear lower strut bar
-sparco steering wheel
-HASPORT urethane motor monts
-Super flow fuel filter
-JDM front bumper
-type R intake manifold
-DAC cold air intake
-Shaved antenna
-clear corners
-viper alarm
-Fidanza lightweight flywheel
-Stage 3 ACT clutch
-AEM cam gears
-Aem fuel pressure regulator
-B&M short shifter
-Apexi AFC controller
-DC sports 1 piece header
-dc sports high flow cat
-2.5" custom exhaust w/ apexi bomb muffler
-auto meter pro-comp ultra lite VAC AND VOLTS guages(pilar pod)
-Tokico shocks
-skunk2 coilovers
-Freedom design front upper strut bar
-dc sports rear lower strut bar
-sparco steering wheel
-HASPORT urethane motor monts
-Super flow fuel filter
-JDM front bumper
-type R intake manifold
-DAC cold air intake
-Shaved antenna
-clear corners
-viper alarm
#48
08-13-2004, 08:38 PM
RE: Need Info to make car go fast!
ORIGINAL: JDMB16CIVIC
i have a 1990 honda civic hatch with a JDM B16 DOHC VTEC that i am trying to get rid of because there is a hole in the block due to water being sucked in my intake. the head and 5spd trans have less then 50,000 miles and it is an easy fix. You could get a block from a junk yard for $150. the car is very fast and will spin the tires in 4th gear! REDLINE IS 9500 RPMS and will hit 120 in 4th like nothing.here are the mods...
-Fidanza lightweight flywheel
-Stage 3 ACT clutch
-AEM cam gears
-Aem fuel pressure regulator
-B&M short shifter
-Apexi AFC controller
-DC sports 1 piece header
-dc sports high flow cat
-2.5" custom exhaust w/ apexi bomb muffler
-auto meter pro-comp ultra lite VAC AND VOLTS guages(pilar pod)
-Tokico shocks
-skunk2 coilovers
-Freedom design front upper strut bar
-dc sports rear lower strut bar
-sparco steering wheel
-HASPORT urethane motor monts
-Super flow fuel filter
-JDM front bumper
-type R intake manifold
-DAC cold air intake
-Shaved antenna
-clear corners
-viper alarm
i have a 1990 honda civic hatch with a JDM B16 DOHC VTEC that i am trying to get rid of because there is a hole in the block due to water being sucked in my intake. the head and 5spd trans have less then 50,000 miles and it is an easy fix. You could get a block from a junk yard for $150. the car is very fast and will spin the tires in 4th gear! REDLINE IS 9500 RPMS and will hit 120 in 4th like nothing.here are the mods...
-Fidanza lightweight flywheel
-Stage 3 ACT clutch
-AEM cam gears
-Aem fuel pressure regulator
-B&M short shifter
-Apexi AFC controller
-DC sports 1 piece header
-dc sports high flow cat
-2.5" custom exhaust w/ apexi bomb muffler
-auto meter pro-comp ultra lite VAC AND VOLTS guages(pilar pod)
-Tokico shocks
-skunk2 coilovers
-Freedom design front upper strut bar
-dc sports rear lower strut bar
-sparco steering wheel
-HASPORT urethane motor monts
-Super flow fuel filter
-JDM front bumper
-type R intake manifold
-DAC cold air intake
-Shaved antenna
-clear corners
-viper alarm
Last I checked even the JDM B16s redlined between 8000-8500 rpm.
I see no hondata/uberdata with programmed chip and higher lift vtec cams...sooo... theres no way the motor is supposed to be spinning out to 9500 rpm.
#50
07-18-2005, 10:38 AM
RE: Need Info to make car go fast!
ORIGINAL: geek
So............... you wanna make them car go fast eh. Well, instead of spending thousands why don't i just shove you & your civic into my yukon for free and i'll do the 0 to 60, and for sure you'll feel exactly how it's like to ride in a fast mobile. There's plenty of road here in the big city of southern Alberta, Canada to do just that.
happy hanukah
Geek Hopfe
So............... you wanna make them car go fast eh. Well, instead of spending thousands why don't i just shove you & your civic into my yukon for free and i'll do the 0 to 60, and for sure you'll feel exactly how it's like to ride in a fast mobile. There's plenty of road here in the big city of southern Alberta, Canada to do just that.
happy hanukah
Geek Hopfe
Thread
Thread Starter
Forum
Replies
Last Post
EG SWAP INFO NEEDED, I NEED EVERYONES INPUT SO THAT I CAN MAKE A STICKY ON THE GROCERY LIST!!!!!!!!!
MarcB
EG Swaps
12
05-02-2007 01:20 AM
