DIY Aftermarket Grill on an EK

Printable Version

Honda Civic >> General Automotive >> DIY - Do It Yourself >> Exterior Modification DIYs >> DIY Aftermarket Grill on an EK

Page: [1]

Login Message << Older Topic   Newer Topic >>

DIY Aftermarket Grill on an EK - 10/10/2006 8:10:41 AM    Forty04 Posts: 14155 Joined: 3/8/2005 Status: offline I'm not sure whether or not the 96-98's are the same as the 99-00's, but I've been meaning to do this DIY for a long time, so, here goes... Start by removing the grey clips on top of the bumper/grille Remove the bolts on the underside of the front bumper holding it to the water gaurd. There should be two screws and a couple clips if I remember correctly. Then there are two stubborn little screws in the wheel wells (pictured below). There is one in each wheel well holding the back of the front bumper in place. Remove these screws. In this image I am pointing at where the screw sits inside the well; it sits up in that little hole you see directly in front of my finger Completely pull the front bumper cover off the car, and remove the screws holding the bottom of the grille to the front bumper cover as shown below. Pop in the new grille, work backwards through these steps for re-assembly, and you're good to go. Finished product pictured below.. Oh yeah, and don't forget to have yourself a beer during the install, it's more fun that way _____________________________ Please do not PM me with tech questions. Basic stuff can be found by using the search feature. My04Civic HCF: i love sausage Post #: 1

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Honda Civic Prices

Honda Civic
Civic Si Concept

Featured Sponsors
Select A Model Accord CR-V Civic Civic Hybrid Element Fit Odyssey Pilot Ridgeline S2000

Top 10 Posters
forty04 14155 remmy 11161 fiirkan 10322 mill$civic 8433 marty 8262 mxs 8005 nail i3unny 7705 sacicons 7674 fliphkd720 7589 pete 7169

New Vendors
AMSOIL - Performance Oil Technology
K&N Engineering, Inc.