Go Back   HondaCivicForum.com > General Forum Information > New Member Introductions




Reply
 
Thread Tools Search this Thread
  #1  
Old 07-02-2008, 10:45 AM
PushnFords PushnFords is offline
My Garage
 
Join Date: Nov 2007
Location:
Posts: 21
Default New Member in Kansas

I actually joined a while back when I first bought my '94 DX. My poor car has had a hard life. I bought it just after it was wrecked. They hit something with the LH front fender that mangled it, bent the hood, and tore the front bumper cover. The car also slid backwards into a pole and that manged the rear bumper cover and dented the trunk lid. I paid $500 (supposed to run fine) and took it home. I found an inner bumper off eBay so I installed that with new foam and got the bumper cover to fit good enough that the accident damage wasn't too noticable in the back. Couldn't do much with the front. I cleaned it out really well and did a tune up, replaced tie rod ends, muffler, stereo, timing belt, etc. Didn't drive it much before I realized the head gasket was blown...the seller's son had overheated it. I changed the head gasket and the car ran good but smoked and burnt a quart of oil every 250 miles. It still got 33-34 mpg so I ignored it and hoped it would hold together until summer.

Then one day I was driving in town with my wife and came up to a stop sign. Waited for 5-6 cars to go by. There was a parking lot on my left...full size Dodge 4x4 sitting in the first parking spot, then the lot entrance, then another full size 4x4. I couldn't see anyone so I started to pull out. As soon as I got even with the parked trucks I could see a car flying down the road...I gunned it but she hit the rear 8-10" of my car on the driver's side. She never swerved (there was empty parking spaces behind me so the road was basically two lanes wide), never hit her brakes, nothing. It was a 20mph zone but she managed to cover the distance of three parked trucks and hit me hard enough to spin me 90 degrees. The cop said they couldn't prove how fast she was going but I had a stop sign so they gave me the ticket. The impact raised the trunk 2-3" on the driver's side and pushed it over an inch towards the passenger side. I had a body shop pull the corner of the car down ($150) and I found another inner bumper, foam, and bumper cover in a local junkyard ($35). A couple thousand miles later the engine started to overheat and smoke a lot worse so I parked it. Just finished pulling the engine last night. Going to try to either rering it or have it bored and do a stock rebuild on it.

This is how the car looks now:





Damage from accident ina 20mph zone:


How the back looks now:
Reply With Quote
Sponsored Links
  #2  
Old 07-02-2008, 12:13 PM
macbeth18288 macbeth18288 is offline
HCF Member
My Garage
 
Join Date: Jan 2008
Location: St. louis, MO
Posts: 1,305
Default RE: New Member in Kansas

Man that car has had a rough life to say the least
Welcome to the forum
__________________
JP

2001 Civic EX Coupe
MT

"Hokey religions and ancient weapons are no substitute for a good blaster at your side”
Reply With Quote
  #3  
Old 07-04-2008, 10:06 PM
kybok kybok is offline
My Garage
 
Join Date: Jul 2008
Location:
Posts: 9
Default RE: New Member in Kansas

welcome... where are you in ks... trying to meet some peeps with ek's from the ks area
__________________
Reply With Quote
  #4  
Old 07-09-2008, 08:39 PM
Wheelbroker Wheelbroker is offline
My Garage
 
Join Date: Apr 2004
Location: United States
Posts: 594
Send a message via Yahoo to Wheelbroker
Default RE: New Member in Kansas

Alittle flag from your home state for you...Welcome

WheelBroker

[IMG]local://upfiles/37/C2A81FF335AC4DAB94A72A9833CA4AD6.gif[/IMG]
__________________
" ING - It's A Game I Play "
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Advertising

Featured Sponsors


New Sponsors
AMSOIL - Performance Oil Technology
K&N Engineering






All times are GMT -8. The time now is 02:50 PM.

Internet Brands, Inc.
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.