HondaCivicForum.com

 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: 99civic_boosted
Showing results 1 to 25 of 196
Search took 0.03 seconds.
Forum: Mechanical Problems & Technical Chat
Jul 5, 2006, 12:49 AM
Replies: 18
Views: 1,895
Posted By 99civic_boosted

RE: crankshaft bolt

Drive to a machine shop. For $5 to $10 they will spin it loose, snug it back up. Drive home and change out the belt.
Forum: General Civic Talk
Jun 16, 2006, 04:15 AM
Replies: 2
Views: 705
Posted By 99civic_boosted

RE: I need some help

Everytime I have seen this happen (3 times) it has been the window regulator gone bad.
Forum: Mechanical Problems & Technical Chat
Jun 16, 2006, 04:09 AM
Replies: 9
Views: 1,671
Posted By 99civic_boosted

RE: clicking sound

I agree with (lol) mygroin (<= that's funny) I usually try to not listen to mygroin as it can get me in to trouble. (sorry got carried away).

Start with checking out the CV shafts. I have had...
Forum: Mechanical Problems & Technical Chat
Jun 16, 2006, 01:36 AM
Replies: 11
Views: 1,403
Posted By 99civic_boosted

RE: Not start....

Not sure about an 84, but the ICM is found inside the distributor in the newer stuff and yes it will cause it to spark once and then nothing after that until you shut the key off then back on. I...
Forum: Mechanical Problems & Technical Chat
Jun 14, 2006, 07:13 AM
Replies: 5
Views: 24,861
Posted By 99civic_boosted

RE: p1456

The best way I found to find a vacuum leak is with a can of carb cleaner.

With the car running, spray around all your hoses and listen for the idle to change. It can go either way (up or down)....
Forum: Suspension, Brakes, Tires & Wheels
Jun 8, 2006, 01:58 AM
Replies: 8
Views: 3,110
Posted By 99civic_boosted

RE: CV Boots ? Help!

Sliding a small screwdriver between the shaft and the boot to allow any air pockets to escape before clamping it down on the shaft.
Forum: Nitrous, Super Chargers, & Turbos
Jun 2, 2006, 08:04 PM
Replies: 4
Views: 946
Posted By 99civic_boosted

RE: illegal?

In the state of AZ, it is legal to have nitrous installed in your car, but illegal to have it connected to the tank while on a public street or highway. This of course helps you in no way because...
Forum: Inside and Out
May 24, 2006, 07:41 AM
Replies: 7
Views: 883
Posted By 99civic_boosted

RE: invader hood

Probably won't help you much but try looking here

http://www.customautotrim.com/bodykits/
Forum: Engine & Internal
May 24, 2006, 01:44 AM
Replies: 6
Views: 837
Posted By 99civic_boosted

RE: looking for rings.

Pistons are like $50 a piece from Honda but I really don't think you need them. The rings are about $30 from Honda as well.

Here are the two sites I use when looking for Genuine Honda parts.
...
Forum: Mechanical Problems & Technical Chat
May 24, 2006, 01:34 AM
Replies: 8
Views: 4,962
Posted By 99civic_boosted

RE: Rough Idle

While you're at it, with the engine running, take that can of carb cleaner and spray all your vacuum lines. If the idle changes (up or down) you have a vacuum leak at that hose and needs to be fixed...
Forum: Engine & Internal
May 24, 2006, 01:21 AM
Replies: 10
Views: 1,666
Posted By 99civic_boosted

RE: Nitrous and Turbo

Solved mine.

But as Nail I3unny stated "aftermarket motor mounts" but they also cause the car to viberate a little more since there is less give.
Forum: The Lounge
May 24, 2006, 01:16 AM
Replies: 12
Views: 1,196
Posted By 99civic_boosted

RE: bank account?

depositing ? Yeah sure, that's what i'll do [sm=grinangel.gif]
Forum: The Lounge
May 23, 2006, 03:04 AM
Replies: 12
Views: 1,196
Posted By 99civic_boosted

RE: bank account?

Send me your account number and SS number and I'll see what I can do.

:D
Forum: Nitrous, Super Chargers, & Turbos
May 23, 2006, 02:58 AM
Replies: 5
Views: 993
Posted By 99civic_boosted

RE: Greddy kit w/ Emanage on 00 si?

It is the bottom half of the engine that is needed for the turbo if you go nuts on the PSI. Pistons, rods and a block guard.
Forum: Engine & Internal
May 23, 2006, 02:54 AM
Replies: 10
Views: 1,666
Posted By 99civic_boosted

RE: Nitrous and Turbo

The only way I would recommend using the two together is with a "Pressure Deactivation Switch". The nitrous system disengages once the turbo has achieved a set boost level. This would eliminate the...
Forum: Mechanical Problems & Technical Chat
May 20, 2006, 02:37 AM
Replies: 12
Views: 1,556
Posted By 99civic_boosted

RE: broken bolt

If the bolt is broken off and you can't grab it with a bolt extractor or use an easy-out, then using an Oxy/Acetylene torch is a very good way to remove it. However, the way I have done it is slick...
Forum: General Civic Talk
May 16, 2006, 04:37 AM
Replies: 5
Views: 736
Posted By 99civic_boosted

RE: Misplaced Civic

Sorry to hear that man. That just SUCKS!

Hope you have insurance to cover it.

Good Luck
Forum: New Member Introductions
May 16, 2006, 04:32 AM
Replies: 6
Views: 528
Posted By 99civic_boosted

RE: HI

Welcome to HCF
Forum: New Member Introductions
May 16, 2006, 04:31 AM
Replies: 10
Views: 829
Posted By 99civic_boosted

RE: What up

Welcome and hope you enjoy the site
Forum: General Civic Talk
May 9, 2006, 07:14 AM
Replies: 14
Views: 2,788
Posted By 99civic_boosted

RE: Window Problems

Sorry, what I meant by crossed is That is where they are hinge together. There is like a big rivit that holds them together and it gets worn out allowing the window to shift in all directions.
Forum: The Lounge
May 9, 2006, 07:09 AM
Replies: 6
Views: 576
Posted By 99civic_boosted

Bidding on Ebay

Now THAT is a good deal. Check out the bid history down at the bottom.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=9515777951&rd=1&sspagename=STRK%3AMEWA%3AIT&rd=1
Forum: General Civic Talk
May 8, 2006, 07:15 AM
Replies: 14
Views: 2,788
Posted By 99civic_boosted

RE: Window Problems

I have only seen this problem a couple of time, but both times it turned out to be the window regulator was worn out were the two bars cross.
Forum: Transmission & Differential
May 8, 2006, 06:48 AM
Replies: 2
Views: 1,081
Posted By 99civic_boosted

RE: trany or clutch question

Sounds like it could be your throwout bearing. When the noise starts, push the clutch in just enough to make the T/O bearing touch the pressure plate but not enough to dis-engage the clutch. If the...
Forum: New Member Introductions
May 2, 2006, 02:39 AM
Replies: 5
Views: 501
Posted By 99civic_boosted

RE: new

Welcome to HCF
Showing results 1 to 25 of 196
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 11:45 PM.