hi there

new here, im from England and i have a blackeg with a B16a2 in it.

basically im good with mechanics - i done my engine conversion myself, etc but i suck at electronics on cars (bad)

basically can someone do a step by step of how to install a apexi neo.

i can wire it in myself fine - but its the intial set up i need help with. heres what i know (and dont lol)

(operations)

-obviously at start i set 'V/T control on'
-ill set it to easy
-(car select - this is where i start getting confused) obviously i select '4 cylinders' the what do i need to do for 'throttle type'?

- for air sensor select ive been told i should select 'pressure type' - but then what do i put for the 'IN' and 'OUT' settings? (think i read somewhere i should put 6 for both - is that right?)

-then do i have to set warnings?

im really sorry if this post sounds bad but im confused and am dying to get this on my car.

ANY help is greatly appreciated beleave me

thanks