90 ef 4 door getting its first swap
 

im about to do a d16z6 swap on my 4 door, im looking for tips in getting this whole process done. mainly the wiring, do i use a z6 complete harness, or do i splice into my ef harness, and also do the z6 axle splines match up to the ef spindle bearings, or should i just use my 1.5 trans? thanks all...

No need for three of the same thread.

You should do some research. These cars are roughly 20+ years old. Anything that can be done to this chassis has been documented and asked about over and over again.

sorry buddy, new to all this, do u hav any suggestions?

No problem.

Honestly, google.com, or honda-tech would be the best source of knowledge for most everything. It is a little slower on this forum, but we want you to stay and keep posting here! ;)