I am at the midway point of swappin a b16 into my 93 dx. It feels good to be at this point seeing as i started by driving out here ten hours on wednesday to find the shell that i bought 100 yards out in a field frozen to the ground. But we now have the motor out and are ready to install the b16. Also to go along with it I have DC sport header and a beautiful greddy evo exhaust. I took some video tonight of us pulling the engine, took about 4 hours, and when I get a chance I will post some of it.

 

nice project! where are you located?

 

suburbs of d-town

 

well I got everything in and installed, had a shop cut and fit my linkage so it would work, they went to back the car out of the garage, and the tranny was shot. So now I am looking for a tranny to install. the kid I bought the motor from is trying to say that it is a bad slave cylinder on the hydro to cable conversion kit, but the problem i have with that is when I push my clutch in and put the car in gear it goes fine, the noise comes when I start letting the clutch out. I will let ya'll know when it gets running.