I was in a rush today moring and I floored my car for like 30 miles strate not slowing down. I have a D16Y7 engine, I was wondering
if my engine could be push like that? or is there going to be some problem with my engine if i do that too much.

 

were you highway driving? or stop and floor it and shfit and floor it red line floor it?

 

it will shortn the life of ant motor to drive at high rpm, some more than others ...

 

Yes and no, depends on the condition of the engine.

Your engine can be run at high RPMs steadily for an extended period of time if the engine is in good condition. There should be no problems unless the oil's viscosity starts breaking down or the temperature of the engine exceeds the normal range.

 

i have the same motor..i posted a question about this a wile ago, and a very very knowledgeable person told me that i shouldent run it over 4000 rpm for a long period of time, (thats going about 160km/h)

 

I dont think that it would be that bad really. Considering its potential power is majorly crimped from the factory. The Y7 in my opinion can take the beating and can handle a lot more in most situations.

 

i only floor it twice from a red light

most of it was highwy driving, i push my car all the way up to like 100+ it was fun

 

If it's still running good your are ok.

 

if it sounds and acts normal than you are OK

 

my point was, an engine pushed hard everyday, will not last as long as one driven the same mileage at normal rpms.. the harder you work it, the more wear there will be.. oncein a while. should make no difference