Hey guys I could really use some help. I mentioned that when I started posting here I was swapping a Z6 into my 89 civic chassis. The swap should've taken place by now but my mechanic had some money issues (damn recession) and had to pull out at the last minute. Its been about 2 months now and in my hunt for a mechanic I started doing some extensive research and asking opinions about this motor. I am new in the Honda world and am still learning a lot. A lot of peoples first opinions was scrap the d series and go b. I'm not ready to do a b series yet. As I said i'd like to learn and mess around with a motor that will be a little less pricey but with decent power. My second response from people was go turbo. I did A LOT of thinking and this is the route i wanna take. However I am without professional opinion or guidance and dont wanna go to a new mechanic with very little knowledge that I dont know or trust. Can someone please just give me a few minutes of your time and tell me what I need for the setup. I would like to keep all the parts with 'names' such as skunk 2, apexi, greddy, so on and so forth. Im a bit **** like that. so if someone could please help me out i would greatly appreciate it. thanks so much guys. if the list is a bit extensive maybe you could email it to me. Zmicevski@yahoo.com Again. I really really would appreciate any and all help i could get with this.