Hey I just joined and I just put some projection headlights on my 1995 Civic today. I did not connect the halo wires because 1) Im not 100% sure how to. and 2) The turn signal lights are already very clutters from light add-ons from the previous owner. Is it possible to connect the wires for the halos on the projector or highbeam light for a power supply? Or does anyone know of a good sight for the wiring of the halo/projection head lights? I have pictures I can post of the wires if needed. Thanks! Rob.

 

I never dealt with halo lights because everyone who gets them ends up hating them.......the WILL fog up.....eventually they all do. My honest opnion is for u to return then and get a HID kit. Welcome to the site!

 

use our search button and do a search on halos, theres lots of threads about hooking them up..most people just splice them into the fogs, others wire them to a switch

to stop them from fogging...get some clear silicone and seal them up around the seem again

 

You can also connect them to the parking lights (thats what i did).
P.S. welcome to hcf

 

Im using some tacky glue like caulking around the seams, but on the halo wires, there is a black and red for each halo (4 halos)..so 4 black 4 red wires, and i assume the red is power, and black is ground, so if i strip a section of the white wire for my forlights (from rely there are 2 white, and a black which is grounded) so 2 red on each of the white foglight wires After the rely, and then just all the black screwed down for a groud? and would I have to put a bigger/smaller fuse for the foglights then? Sorry for all the complicated questions -Rob