I have a 95 civic ex coupe with a d16z6 and a chipped p28 ECU. I am trying to use crome to tune my car. But when iput a chip inthe CEL comes on. I dont think that it is a hardware error and its not the checksum routine.If i do drive it with the light on it sounds very lean and acts like its got a rev limiter at 4k even though i have it set for 7500. My dad is an electrician and says the soldering looks fine. I really want to get crome running but with pgmfi.org gone its hard to find help.

 

go register over at pgmfi.org. im sure they can give you a definite answer on this issue.

 

Huh? it's not gone.