Project HCF
Thread Starter
|
HCF Member
Joined: Jan 2005
Posts: 11,248
From: Charleston
RE: Project HCF Update
12/16
Ok, the old motor was broken into and looked at. I didnt have 'a' wrist pin problem... more like all wrist pins were destroyed beyond recognition. Come to find out, My motor was semi built. It has Crower rods. Thy are actually fine, including the crank shaft and bearings.
The cylynders are decimated and the pistons are also. There is shrapnel all through the motor as you will see int eh following pics.
Here is an excerpt from my mech:
Learn from that people ^
Ok, the old motor was broken into and looked at. I didnt have 'a' wrist pin problem... more like all wrist pins were destroyed beyond recognition. Come to find out, My motor was semi built. It has Crower rods. Thy are actually fine, including the crank shaft and bearings.
The cylynders are decimated and the pistons are also. There is shrapnel all through the motor as you will see int eh following pics.
Here is an excerpt from my mech:
"Dude, your motor is toast. All 4 pistons are f***ed up, your rods are fine, and your crank is probably fine, there were no spun bearings. Honestly, the problem was whoever built the motor, they installed the circlips wrong (and used ****ty ones) on the wrist pins, every circlip had disintegrated, and that was the start of all the problems. So, you had 4 wrist pin problems. Your cylinders are gone… 4 looks best, but they’re all destroyed. Here are some pics"
