View Poll Results: Did you measure, mill, or go on faith with head gasket replacement?
I checked for flatness and then milled.
0
0%
I checked for flatness and it was within spec so I did not mill
0
0%
I did not check for flatness, just re-used HG. It leaked again
0
0%
I did not check for flatness, just re-used HG. It was fine.
0
0%
I did not check for flatness, just submitted to a machine shop. They milled
0
0%
I did not check for flatness, just submitted to a machine shop. They said milling not necessary
0
0%
Machine shop said my head was out of spec for flatness
0
0%
Machine shop said my head had a pressure leak
0
0%
Voters: 0. You may not vote on this poll
polling: Did you mill your head with HG replacement
polling: Did you mill your head with HG replacement
Thread
Thread Starter
Forum
Replies
Last Post
