I have an oil leak... From Where it is I know Its high on the engine and ether on the transmission end or the firewall side tward the passenger side of the engine... I looked around on here and I found out it could be the dist. o-ring or the seal in the vtec... I Know where the Dist. is and how to replace the seal... is this the other one?

[IMG][/IMG]

I can tell its been going on for a while... any one have any suggestions on how to get this cleaned up?

[IMG][/IMG]



[IMG][/IMG]

[IMG][/IMG]

 

Bump... Help me please...

 

i had the same prob and it was the vtec solenoid.

 

The top picture... With the green wire plug coming out of it... Is that the Vtec solenoid? How do I replace the gasket or 0-ring thats in there?

 

i say repleace the oring in the distributor, then take to a car wash and pressure wash clean then drive a little and open hood and inspect for oil leaks

 

Is the gasket/seal/o-ring I need in this picture? If it is then what is the number? I would like to get this fixed as soon as possible...

[IMG][/IMG]

 

I can safely pressure wash that area? I figured with all the wiring connectors and the distributor and the air intake right there I would not be able to....

 

i pressure wash mine all the time, all my cars,trucks,jeeps. as long as your not forcing water directly into the intake and distributor your fine.

 

alright... so I already have the dist o-ring on its way... what is the vtec seal that I should replae... I dont want to chance it.... and Thanks for the pressure washer info...

 

#13 in the diagram is the VTEC solenoid gasket and filter