Need an answer quick
 

How do you get off the oil pressure sending unit?

RE: Need an answer quick
 

should just unscrew from the back of the black pull off the rubber cap first and then use a deepwhel socket on it

RE: Need an answer quick
 

I can't seem to get that black cover off. My hand is cramping up like crazy.

RE: Need an answer quick
 

yup its a bitch sometimes. The rubber is all hard and tends to just break off cuz its all dried out.

RE: Need an answer quick
 

you buy any chance dont have some spark plug wire pullers that look like some tongs.... try those if you are having a tough time getting to the back of the block

RE: Need an answer quick
 

orrrrrrrrr just find some kid with smaller hands.....lol

RE: Need an answer quick
 

i just used lots of WD40 and elbow grease...........

RE: Need an answer quick
 

Sounds like he was 'bout to run out of grease though...XCM, you get it yet?

RE: Need an answer quick
 

Not yet, but since last night I haven't really tried. I mounted the turbo and manifold to the engine, but the compressor housing is touching both the radiator fan housing and the a/c compressor hose. The fan housing i can just cut to make room, but the a/c compressor is already pushed back a couple of inches from where it should be? Is it ok for it to be touching?

RE: Need an answer quick
 

Woo got it off finally. My fingers hurt like no other because its really cold out (for this area at least). Only got a little left to do. Gotta tap the oil pan, hook up the downpipe, hook up the MSD and the MF2, do all the vacuum routing and put in my oil.