my buddy out at wyotech can port my head for under $200 bucks, i really know nothing about this and i dont even know if it would be worth doing if im not going over 240whp, but if it is worth the $$ for only 240whp then could someone give me some tips or whatnot on what size to go and whatnot

thx

 

Nope, not worth it really. People make 400+whp on stock port heads, if you want more power, push a bit more boost.

 

what i would do is take that 200 and do a 3angle valve job instead of the port because were the radius bends down into the cylinder is the most important part. The port job if its decent will only give you between 5-15hp at those levels of power