scrap parts left over from old 99civic coupe.
mudflaps both front and rear mudflaps. fronts are well worn from dragging them on speed bumps from my civic being so low, i also cut a few slits into the bottom of the flaps so they would flap back instead of getting ripped off when drugg on a speed bump.

no hardware included.... the fronts use your stock hardware, and the rear i just used some self drilling screws on the outside bumper cover and a zip tie for the inner mounting point. worked just fine for me. just predrill the hole on the bumper cover and tighten the screws BY HAND just snug... its only plastic so if you tighten it to much it can strip.










if theres no takers they will just be going in the trash. your 5bucks is just going towards gas and my time to take it to post office.