Hey guys, this is one of the last things i need for my turbo project. Didder made me one for me but he's been super busy and idk if he'll be able to shipit out to me anytime soon, so i need a different one. I'll throw like $20 at whoever can make this for me:





the dimensions for the top plate as 4" x 4.5", there is 2" of 2" piping (two inches long, piping with a diamter of two inches), then the bottom plate is 3" x 3". 3/8" steel would work the best, and just have the 2" hole centered on each plate. I have a drill press and will be able to drill my own holes, so dont worry about that. I just need the plate welded/center holes cut out. Thanks guys!

 

I can get it made but it may cost a tad bit more than $20, I'll check and get back to you.

 

Marty thatd be sick man, just let me know.

 

So you just need the pipe to be welded to the plate. Which side do you want it welded on?

I can do it for shipping ((we can't charge at the school)) if I have the pipe size you need. I will check Monday morning and see if we have any. And that is 2" inside or outside diameter?

 

lets say inside diameter, and just have it welded to the bottom of the plates, like in between the two, but like, i need the hole drilled in the plates so the 2" hole does all the way through, ya know? (so the exhaust gases can pass on through)

 

Cool beans. Let me see what I can do Monday and I will post some pics up. I should be able to machine the hole and then weld it all up in an hour or so. ((Note: This is if I have the right size pipe. If not it might take a few days))

Do you want this in Stainless or just carbon steel?

 

i dont know much about metal man, whichever will hold up to the heat just fine, but at the same time not be too expensive

 

I will see if we have stainless. It will not rust.

 

alright cool. So you checking tmrw at school? Like could you maybe hit me with a PM tmrw night?

 

PMed. LOL