Camber Kit Installation?
Thread Starter
|
Junior Member
Joined: Jul 2009
Posts: 23
Camber Kit Installation?
I checked to see if there were any stickys or past threads here and I did not find any. I just bought a set of Eibach rear camber kit for a 2000 civic ex. I dont know how to put them on. Is there a DIY guide someone has with possible illustrations? Any help or guidance would greatly be appreciated. Thanks so much
HCF Member
Joined: Oct 2006
Posts: 1,996
From: New York/Up state
Recognized HCF Member
Joined: Jun 2006
Posts: 11,203
From: Brownsburg, IN 46112
theres no DIY needed. its very simple swap. only 3 bolts!
only one bolt that MIGHT be a problem... is the spindles 1 bushing bolt... just like the LCA bolts and bushings they do seize just as bad... BUT with a hack saw or sawzaw its very easy to cut the stock arm off and use some vis grips to remove the rest of the bolt.. the bolt does not seize in the nut itself but it seizes inside the middle of the bushing!
very simple swap!!!
only one bolt that MIGHT be a problem... is the spindles 1 bushing bolt... just like the LCA bolts and bushings they do seize just as bad... BUT with a hack saw or sawzaw its very easy to cut the stock arm off and use some vis grips to remove the rest of the bolt.. the bolt does not seize in the nut itself but it seizes inside the middle of the bushing!
very simple swap!!!
Thread
Thread Starter
Forum
Replies
Last Post
larring1020
Suspension, Brakes, Tires & Wheels
0
Dec 8, 2006 12:55 AM
