OK so I got everything hooked up today to crank the car and see how I did...

Well the Walbro I put in can't seem to push gas from the undercarriage to the fuel rail... all of a foot and a half. Anyone have suggestions??

 

will it pump fuel if the lines not connected? you have a pressure gauge?

 

it'll pump fuel up to the point where the line curves up to the fuel rail, gas doesn't get up to the fuel rail, gauge sensor is after fuel rail. Gauge reads 1-2 psi.

 

OK there is no gas getting past the AEM FPR at the fuel rail, it will get up to the FPR but can't get through to the fuel rail.... any ideas???? besides taking the FPR off? (rather use that as last resort).

 

any kink in the lines will cause that. What fuel pump is it by walbro?

 

check the voltage...you could be using to less to run it being it pushes more fuel

 

Could a -6AN fuel line be too big for the fuel pump?? I am still having the problem of the fuel not being able to push past the regulator... I haven't checked the voltage yet, but I don't think that is the problem.

 

bump