OK. I think i am just going to rebuild my D16Y8 that is in my 97' EX and i wanted to know if the pistons out of a 1.6L DOHC ZC would fit. I have read in Honda Tuning that this can be done and adds a lot of ***** to the little one-six. I beleive the code is PM-7.

 

i read that article too i think, was it the one about "D-series vs. B-series"??

 

pm-7,, p29, and pg6b are what you can use to jack up the compression. pm-7 and p29 are identicle. these can be found either in the dohc zc or the 88-89 d16a1(us) be prepared for high comp #'s and the ability to never run anything below 91 octane. but its fun!