Machine Shop Bill...Ripped Off?
That happened to me once, with some body work. I talked to a lawyer and this is what I have to say. Mention the word BAR and watch em tremble. muahahah. Its the last thing they want to hear. Beuro of automotive repair-BAR. It'll make em honest pretty fast, damn fast matter of fact. In my case the owner threatend to fire the guy who over-quoted me. Additionally, he honered the origional quote. Google it- BAR
Best of luck to ya.
Best of luck to ya.
Its messed up they quotes over a thousand dollars less then they actually charged but I think the final price is reasonable for the amount of work you had done, especially if its a reparable machine shop.
I payed 1000 dollars just for my block and I took my machine shop an almost bare block already hot tanked with just the crank in it. I had it bored and crank polished and balanced then new pistons, bearings, and rods installed.
I payed 1000 dollars just for my block and I took my machine shop an almost bare block already hot tanked with just the crank in it. I had it bored and crank polished and balanced then new pistons, bearings, and rods installed.
OMG, should of shipped it to us man could of had the engine fully built and done shipped back to you for 2K. another $800 and she would of been sleeved with darton's. AT least this way if something happens to the motor i would go back and rap them up the a$$ until you were satisfied.
Believe me, I ASKED AROUND! No one seems to believe me but I did. I called very many shops, these guys had the cheapest estimate and I hadn't heard anything bad about them so I thought what the hell. Makes me scared to ever build an engine again, car gets tuned next week though! I got my 16g evo3 turbo in too!
Riceburner, I would have done that but its too late now. I got ****ed over
lol
Riceburner, I would have done that but its too late now. I got ****ed over

lol
Thread
Thread Starter
Forum
Replies
Last Post
tombakers
Engine & Internal
15
Dec 21, 2007 03:58 PM
fabtoys
Mechanical Problems & Technical Chat
4
Jul 30, 2007 08:13 PM



