would it be worth the effort
#1
would it be worth the effort
i have the '91 body (si hatch) and i have the engine still from my '88 hatch, and from the si. the si has a crack in the number one cylinder. so, would there be any benefit in taking the d15 block and d16 head, i may do it just because all the parts are there, no cost. but if it would run as strong as the si did, pre-crack, then i would most deffinately do it. or how would that setup respond to turbo? it may just be time to start my first turbo!!!
#7
RE: would it be worth the effort
im tired of waiting on this b16, im getting sick of hearing myself ta;lk about it, haha. but it is progressing again. i pick up the head tommorow, just had sk2 valves, retainers, springs, and new seals installed, and had it milled just a little bit to ensure a good gasket seal. with that, the thin head gasket, and stage 2 cams, im hoping to get some good compression and hp...