D16y8 buildup....
#1
D16y8 buildup....
am very new to the Honda engines and we are building an engine for a race car....here is the following mods that we are in the process of doing. The engine is a D16Y8.
Header with 2.5" exhaust
Cold Air Intake with cone filter
COMP CAMS extreme street/competition cam #105300
Head has extensive port work, and has been shaved 40 thousands.
Shortened intake, polished runner and intake
Aftermarket valve springs
Throttle Body off of B18
Chipped OBD1 ECU
Any ideas on what this combination will put out? The bottom end is totally stock, but we have replaced the timing belt. Also, what could I expect power gain wise if I pulled the stock pistons out, bored and decked the block and dropped in some good aftermarket pistons and rods? I am not able to run a "turbo" or do a "swap" so I am stuck with the D16Y8
Header with 2.5" exhaust
Cold Air Intake with cone filter
COMP CAMS extreme street/competition cam #105300
Head has extensive port work, and has been shaved 40 thousands.
Shortened intake, polished runner and intake
Aftermarket valve springs
Throttle Body off of B18
Chipped OBD1 ECU
Any ideas on what this combination will put out? The bottom end is totally stock, but we have replaced the timing belt. Also, what could I expect power gain wise if I pulled the stock pistons out, bored and decked the block and dropped in some good aftermarket pistons and rods? I am not able to run a "turbo" or do a "swap" so I am stuck with the D16Y8
#2
Thread
Thread Starter
Forum
Replies
Last Post
Fiirkan
Pics and Videos
16
12-28-2006 09:16 AM