Splats V6 Civic project
Junior Member
Joined: Apr 2009
Posts: 3
Props on the build this car is going to be sick.
Was there any modification to the clutch line?
If I were to buy a new 6MT tranny from the dealership, what sensors or seals would I need that wouldn't come with it? Or what else would I need for the tranny?
Was there any modification to the clutch line?
If I were to buy a new 6MT tranny from the dealership, what sensors or seals would I need that wouldn't come with it? Or what else would I need for the tranny?
Thread Starter
|
HCF Member
Joined: Oct 2006
Posts: 1,996
From: New York/Up state
So for the past couple of days iv been going nuts, I was told that if i put Acura TL heads on my block, that my numbers will jump from 210Hp and 229Ft 9.4 compression to around 260Hp and 255Ft......and that would be a 3.5 11:1 CR monster, Now this is not final on the facts.....but what it should throw down.
Some things on what i need to get.
Assembled 3.5L engine:
'03 CL-S block/TL-S block
'02-04 Odyssey crank/rods/bearings
'05 RL pistons
'03 CL-S heads
'03 CL-S ported/polished lower manifold (injector base)
'00-05 S2000 fuel injectors (360cc)
My brother told me he found a wrecked 2003 TL Type S motor, so i asked how much....he told me $600.00.
So tomorrow i am dropping that down.
And, my brother also found some nice Acura RL brake Caliper 4 piston, front only, for $200.00, so i am going to jump on this next week.
It will look somthing like this
Some things on what i need to get.
Assembled 3.5L engine:
'03 CL-S block/TL-S block
'02-04 Odyssey crank/rods/bearings
'05 RL pistons
'03 CL-S heads
'03 CL-S ported/polished lower manifold (injector base)
'00-05 S2000 fuel injectors (360cc)
My brother told me he found a wrecked 2003 TL Type S motor, so i asked how much....he told me $600.00.
So tomorrow i am dropping that down.
And, my brother also found some nice Acura RL brake Caliper 4 piston, front only, for $200.00, so i am going to jump on this next week.
It will look somthing like this
Last edited by SPLAT; Aug 5, 2009 at 05:52 PM.
Thread Starter
|
HCF Member
Joined: Oct 2006
Posts: 1,996
From: New York/Up state
Well i put some money down on my new J32, so now i have to wait about a week or 2 till it comes.
But on a side note......some more pic's of some things.
My V-AFC2 Apexi Vtec Control.
Civic Type R X Peddles
New lug nuts by MUTEKI my friends say they look like little black Olive's......They say the stock chrome ones looked better.....i dont know.
Car sitting out side for a bit, took her around the block.......in 4th gear, the tires still chirped.
New air intake......filter.
More to come shortly.
But on a side note......some more pic's of some things.
My V-AFC2 Apexi Vtec Control.
Civic Type R X Peddles
New lug nuts by MUTEKI my friends say they look like little black Olive's......They say the stock chrome ones looked better.....i dont know.
Car sitting out side for a bit, took her around the block.......in 4th gear, the tires still chirped.
New air intake......filter.
More to come shortly.
Last edited by SPLAT; Feb 6, 2010 at 07:24 PM.
J/K
Thread Starter
|
HCF Member
Joined: Oct 2006
Posts: 1,996
From: New York/Up state
While i was driving the car back from the shop, my inner fender plastic fell off some how, so i tied it up for now.
I want to put the carbon fiber hatch on.......but i feel i should wait till the whole car is repainted this winter.