I just brought another Honda Civic but this one is a 98 ex Sedan, I decided that I wouldn't spend the kind of money I did for my 95 Coupe. So First I went and bought a body kit, Which I painted separted, and came out dayum good. Now I'm doing the car.... So far I have did two coats of rustoleum but on my driver side door I have a few runs. I have wet sanded the **** out of it but they are still there.... I was wondering, do I need to just strip down the paint on the door and start over. If so, what would I use to remove rustoleum? ?Paint remover?

 

Just keep sanding. Do you have any pics of your progress?

 

sorry for the bad pictures ..... its a cloudy day.....

[IMG]local://upfiles/22460/1CB466952A8643BDB0089289B067009E.jpg[/IMG]

[IMG]local://upfiles/22460/FA23EFD639EF4AA88EA3273E8F3B6ABA.jpg[/IMG]

 

bump for any help?

 

Just wet sand them down until they are gone. If you strip the paint, you'll have to prep the steel, prime and then paint again. Easiest is to just wet sand the runs down, touch it up with a few shots of rattle-can, then continue on. If you are having a hard time removing them, you probably have too fine of a sandpaper.