sjyj

 

does the write up apply to gsr leather?

 

No variables change when installing GSR leather seats, other than be very careful not to rip or tear the beauty of those seats lol

 

Nice Job on the write up! I hope to put some ITR seats in my EM1!

 

That should allow you to test the limits of that car a little better. I found i could push my car a little harder cuz i stayed within a useable range of motion from my standard seating position. not like the stock seats where i was basically holding onto the steering wheel to turn. But remember to push your car on the track and not on the streets

 

So, when swapping the rails do you need the entire bracket or just the actual sliding part of the bracket (that bolts into the floor) I am doing the exact same install and cannot get the holes to line up right..Ive only got 3 out of 4. This is on the Driver's Side seat..Which is the only one Ive worked on so far. I put JUST the sliding part of the bracket onto the left side of the seat and the front bracket hole will not line up on that side..Do I need to replace the entire bracket? (Including the side rail w/ the seat adjustment coil) ???? I replaced the entire bracket on the right side of the seat and it lines up fine. I cannot get the left side to work though with just the slider and not sure if I have to take the entire side rail and bracketing off the Civic seat and replace the Integra seat's with it