View Poll Results: A poll
No, it's easy enough anyway.
0
0%
No, not enough people would use it.
0
0%
Voters: 12. You may not vote on this poll
Want an o2 Simulator DIY?
HCF Member
Joined: May 2006
Posts: 299
From:
RE: Want an o2 Simulator DIY?
ORIGINAL: FlipHKD720
http://o2simulator.com/28301/index.html
Explain how to do it then.....im not being cocky, thats a legit question. It even says that you can solder, use heat shrink tubing and stuff, and those are the things you use when you cut wires isnt it?
ORIGINAL: Remmy
Dont cut any wires.
Dont cut any wires.
Explain how to do it then.....im not being cocky, thats a legit question. It even says that you can solder, use heat shrink tubing and stuff, and those are the things you use when you cut wires isnt it?
i didnt make it, just bought it.
Thread Starter
|
HCF Member
Joined: Mar 2006
Posts: 8,442
From: Marquette, MI
RE: Want an o2 Simulator DIY?
Talon you just had to splice into the 3 wires from the O2 sensor, then just seal it up real good right? I don't wanna do a DIY on it and mess it up. lol
Joined: Sep 2005
Posts: 1,173
From:
RE: Want an o2 Simulator DIY?
Actually mine came pre-made with o2 connectors and everything. All I did was take off the rubber grommet off of the stock secondary o2 sensor harness, then i shoved all the extra wires back up in the car and re-attached the grommet near the simulator so it looks kinda clean. Hope i didn't confused you. If you lived closer to me id show you what it looks like.
this is the company i bought it from but they dont sell simulators anymore
http://www.casperselectronics.com/
this is the company i bought it from but they dont sell simulators anymore
http://www.casperselectronics.com/
Thread
Thread Starter
Forum
Replies
Last Post
