Mechanical Problems & Technical Chat If you've got a problem you just can't figure out, a noise you can't diagnose, or a check engine light that won't go away, ask about it here!

96 civic stalling

Old Jan 12, 2010 | 05:11 PM
  #1  
bowtiekidd's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2010
Posts: 4
Default 96 civic stalling

My son has a 96 civic that is all stock and for the past couple of weeks when he comes to a stop after driving for awhile the car will just stall. He says the car will turn over but will not start but here is the strange part if someone boosts him off with jumper cables the car cranks. I had him take to AutoZone today to have the battery and alternator checked and they are both fine could this be a battery cable issue? I saw allot of people with the same issues but really no solutions.
 
Old Jan 12, 2010 | 05:14 PM
  #2  
mk378's Avatar
Recognized HCF Member
Joined: Jun 2007
Posts: 10,023
Default

Check that the connections at the battery are secure. When you put jumper cables on you bump them and may tighten it up temporarily.

If the car drives OK but stalls when stopped, see if pressing the gas slightly will keep it going. If so, the IACV may just need cleaning.
 
Old Jan 12, 2010 | 05:24 PM
  #3  
RonJ's Avatar
Recognized HCF Member
Joined: Sep 2007
Posts: 9,453
From: Houston, Texas
Default

Is the CEL on? Any CEL codes? What trim -- CX, DX, or EX?
 
Old Jan 12, 2010 | 06:03 PM
  #4  
bowtiekidd's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2010
Posts: 4
Default

now engine light or codes I think it is a DX it is very basic no power anything
 
Old Jan 12, 2010 | 06:04 PM
  #5  
bowtiekidd's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2010
Posts: 4
Default

sorry can not type no check engine lights or codes
 
Old Jan 12, 2010 | 07:00 PM
  #6  
RonJ's Avatar
Recognized HCF Member
Joined: Sep 2007
Posts: 9,453
From: Houston, Texas
Default

Does the CEL turn on and then off after 2 seconds when the key is turned to ON(II)? That's how you know the CEL works and there are no codes.
 
Old Jan 13, 2010 | 06:23 PM
  #7  
bowtiekidd's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2010
Posts: 4
Default

Just got back in town and I found that the negative cable was loose and corroded, cap and rotor looked bad plus some how the bolt had fallen out of the rotor and was laying in the distributor. I replaced all of the parts and at this moment it is running fine, thanks for the help.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
blahwoop
Mechanical Problems & Technical Chat
5
Jun 25, 2007 10:27 AM
angie828
Mechanical Problems & Technical Chat
0
Oct 4, 2006 10:23 AM
onetrack
Mechanical Problems & Technical Chat
2
Sep 24, 2006 02:15 AM
kevv9
Mechanical Problems & Technical Chat
7
Oct 2, 2005 11:24 AM
91dx
Mechanical Problems & Technical Chat
1
Nov 13, 2004 02:27 AM


Thread Tools
Search this Thread

All times are GMT -8. The time now is 12:59 AM.