Low compression 97 1.6

I know its on the #1 cylinderand its not the valves.

What do i need to fix? is there a kit?are any special tools needed to do the job?

I was told it can be done with the engine in the car but i need to swith out the tranny anyways soill just pull them both out.

the car has 150k on it, Any tips on what should be replaced while i have the engine and trans pulled?

 

A wet versus dry compression test should be done to distinguish a bad piston ring from a blown head gasket.

 

When oil is added tothe cylindercompression is good.


mysighnature is not working?
http://cia-gamers.com/members/car.JPG

 

Here's where to start:

http://hondatech.info/downloads/Auto/Manuals/Civic/

Is replacing the engine an option that you have considered?

 

I would rather fix this engine, I have already put in a new water pump and timeing belt.
And other then cylinder 1 it'sa good engine.

If itis cheaper to get a used enginethen maybe, but at a junk yard you dont know what your getting.


I have a Haynes Repair Manual its for..

civic 96-2000
cr-v 97-01
integra 94-2000

Iliketo get some help andtipsfrom the forums b4 the job, I plan to do this next weekend.
A manualcan't help with on hand question