Overheating. HELP ASAP
My car is completely topped off with antifreeze and the fan is working and everything but when im sitting with my car running at an idle my car starts to overheat (kinda sucks at red lights) but when i can on it the heat guage instantly droppes back to normal. i was thinking it has something to do with the thermostat but im not too sure. if so how much does this fix cost
It's like ... under $20 for a thermostat and thermostat gasket. And to bleed, on your Civic at least, just open the radiator cap and let the engine run. There's no bleed screw. Just be sure to top the radiator off if needed. Pull the temp thing on your climate control to full heat and let it run until the radiator fan turns on and off twice.
Last edited by WellFedHobo; Mar 31, 2009 at 08:24 PM.
just replace the thermostat, its easy and cheap. The lower radiator hose might be really hard to get off so you might have to cut it and buy a new one. Check to make sure you can get it off before you go buy the thermostat so you dont have to make two trips to the auto parts store. GL
A thermostat is a very cheap "repair" but if you are getting air in your system requiring it to be bled, then it is happening for a reason. It doesn’t just get air in the system. Have you done any recent work that required the cooling system to be opened up (radiator or rad hose changes, etc)? Have you ever replaced the water pump? I believe it is ran off the timing belt so if it’s leaking you might not see it until it gets really bad since it is behind the timing belt cover.
In any case of overheating, after making sure the coolant is full and the fan works, the next step is to just replace the thermostat rather than wonder about it. You don't need to take any hoses off to replace the thermostat. Take the two screws out and open the thermostat housing, push the cover to the side and R&R thermostat and gasket.
When bleeding, it helps to park the car facing uphill if possible so that the radiator is the highest point. At least have it on level ground, not downhill.
When bleeding, it helps to park the car facing uphill if possible so that the radiator is the highest point. At least have it on level ground, not downhill.
In any case of overheating, after making sure the coolant is full and the fan works, the next step is to just replace the thermostat rather than wonder about it. You don't need to take any hoses off to replace the thermostat. Take the two screws out and open the thermostat housing, push the cover to the side and R&R thermostat and gasket.
When bleeding, it helps to park the car facing uphill if possible so that the radiator is the highest point. At least have it on level ground, not downhill.
When bleeding, it helps to park the car facing uphill if possible so that the radiator is the highest point. At least have it on level ground, not downhill.


