What's the worst case scenario?
HCF Member
Joined: Dec 2006
Posts: 578
From: Steinbach, MB
Sorry buddy, I didn't take any pics. I only thought of that after we were done!
The only dicey part (for us) was getting the old bearing off inner spindle (where your CV axle goes through). This is where we used a cutting wheel. Pressing the old bearing out, and pressing the new bearing together took some patience to get it in the right place but wasn't overly difficult. Pain in the a$$? yes. Time consuming? yes. Difficult? no.
And really the whole job isn't that hard, just take your time. Think things through. If you start to panic -- STOP, put down your tools, and think for 5 or 10 minutes. If you lived close by I'd gladly give you a hand with it!
The only dicey part (for us) was getting the old bearing off inner spindle (where your CV axle goes through). This is where we used a cutting wheel. Pressing the old bearing out, and pressing the new bearing together took some patience to get it in the right place but wasn't overly difficult. Pain in the a$$? yes. Time consuming? yes. Difficult? no.
And really the whole job isn't that hard, just take your time. Think things through. If you start to panic -- STOP, put down your tools, and think for 5 or 10 minutes. If you lived close by I'd gladly give you a hand with it!
Thread
Thread Starter
Forum
Replies
Last Post