What ya'll think?
#13
RE: What ya'll think?
Thanks guys. I appreciate all the props. We're gonna start switching all the rest of the interior this weekend (carpert, front & rear seats, etc) so once we do I'll post some more pics.
Motor wise - We have a fully built LS integra motor but not yet installed, before we drop it in we have to redo the rings and valve guides.
Motor wise - We have a fully built LS integra motor but not yet installed, before we drop it in we have to redo the rings and valve guides.
#14
RE: What ya'll think?
got the rest of the front end primered this weekend and we put tilt steering in also. Once I get pics taken I'll get them posted for you guys.
#17
RE: What ya'll think?
the interior was more of a pain then the front end was. We had to drop the shifter out relocate it so it lined up center with the integra shifter boot, had to move the the e brake back about 2 inches, make custom brackets to support the dash and we're still debating what to do about door panels since my stock ones hit the dash and it'll be almost as much work to get the integra panels to go on as it was putting the dash in. We also swapped over steering columns so know I have tilt steering, we had to extended the steering shaft and make custom brackets in order for that to work properly.
The front end was a lot easier. We didnt have it completed but did have it driveable all in about 10 hours. The fenders are 3/4 integra fender and 1/4 my fender. We had to morph the two fenders so we could keep the same body line at the door. We swapped over core supports and hood latch's since my latch was the complete opposite of the integra's. All and all its coming out fairly nice. I have the rest of the front end primered now just been too lazy to take pics but I will today and get them posted for you guys.
Thanks for all the props guys.
The front end was a lot easier. We didnt have it completed but did have it driveable all in about 10 hours. The fenders are 3/4 integra fender and 1/4 my fender. We had to morph the two fenders so we could keep the same body line at the door. We swapped over core supports and hood latch's since my latch was the complete opposite of the integra's. All and all its coming out fairly nice. I have the rest of the front end primered now just been too lazy to take pics but I will today and get them posted for you guys.
Thanks for all the props guys.
Thread
Thread Starter
Forum
Replies
Last Post
n8te81
General Civic Talk
28
02-28-2008 11:26 AM
addiction2bass
General Civic Talk
8
10-16-2007 03:37 PM