whats up..!! so im building a small project something on the side just to have fun... just wanting to hear what you guys kno or have heard of set ups or even if there good product.... MONEY IS NOT AN ISSUE..!!

I have an ls/vtec project going on my head is already been worked on just havent bored it just because im about to work on the block so i can match the bore...

the head is a gsr has p1 buddy club valves stainless steal suppertech retainers titanium and springs brian crower cams i wanted to slap on b16 cam shafts to see if i can still have some high compression but not that high where im over doing it... just havent bored it because the block aint ready yet.. anything else you guys think i can add??


block is gona be mid sleeved darton, cp pistons 9.5:1 compression im thinking of bore of 84mm keeping the stock crank changing out the bearings block is getting cleaned up and some touch ups but what im concerned is the bore to big?? piston are complet set doing 3" pipeing im also slapping this build in an 97 ek coupe couldnt write much im at work writting this haha but let me kno what you guys think or if have any suggestions