I have a B18a block(90' integra) with about 80,000 miles on it. It has everything rods, pistons, crank, oil pump and a good pan w/no dents. VERY CLEAN NO LEAKS!!! $150 takes it

 

damnit I want it, I know a guy that might want it too... since he doesn't want vtec i think it'd be perfect for him... I showed him the thread too.

 

HI! this is 2000Si's friend. i am REALLY interested in this motor. do you have any pics of it? and also how much would shipping be to 46805? thanks!

 

a guys i dont know much about building engines from the ground up but could someone tell me what else you would need besides the rods, pistons, crank....this is all bottom end stuff right? i would need all the top like head cams...what else and do you know what it would cost because i see b18 blocks and headsfor real cheap but the engines themselves are expenseive...iu was just woundering if it is cheaper to just build it by collecting the parts
thanks guys...oh yea sorry to put this in the classifieds but it was a good thread to ask about

 

what state??? shipping woul cost more than im asking for the block..

 

im in Indiana. would you be willing to sell just the head??

 

I dont have the head but if u are interested i have a 1990 honda civic hatch with a JDM B16 DOHC VTEC W/ a 5 SPD cable trans. The car is very fast and will spin the tires lose in 4th gear! REDLINE IS 9500 RPMS and will hit 120 in 4th like nothing.(over $6000 invested)here are the mods...
-Fidanza lightweight flywheel
-Stage 3 ACT clutch
-Unorthadox crank pully
-AEM cam gears
-Aem fuel pressure regulator
-B&M short shifter
-Apexi AFC controller
-DC sports 1 piece header
-dc sports high flow cat
-2.5" custom exhaust w/ apexi bomb muffler
-auto meter pro-comp ultra lite VAC AND VOLTS guages(pilar pod)
-Tokico shocks
-skunk2 coilovers
-Freedom design front upper strut bar
-dc sports rear lower strut bar
-sparco steering wheel
-HASPORT urethane motor monts
-Super flow fuel filter
-JDM front bumper
-type R intake manifold
-DAC cold air intake
-Shaved antenna
-clear corners
-viper alarm
-alpine type r component speakers
-kenwood cd player
-si seats
*body is PERFECT!!! NO RUST
ASKING $5000 email for pics LieutdanL1@comcast.net

 

It depends on what u want to do with the motor. If u want to go fully built for race it would be less expensive to buy a bare block and head then build. If u want something just to start out here is a site to look at.
racenet

 

SHIPPING WOULD BE $150

 

we want it please email euroticelectronics@msn.com