are these any good? and where to put them?

http://cgi.ebay.com/ebaymotors/4pc-S...Q5fAccessories

 

Why are you looking for them if you don't know where they go?

strut tower bars brace the strut towers to each other. tie bars go on the subframe.

They'll be fine, but a 3-point bar will work better. Honestly I think they (ebay bars) look too ghetto to be using as a rear lower tie bar, since that bar is easily visible from outside of the car. Everywhere else is fine though.

 

do you have any other suspension mods? a while ago I was gonna get tower bars cause its a cheap easy mod, but I found out its pretty useless unless you already have a drop.

 

yea i have coilovers and drop the car. So i was just wondering. Would you reccomend something else? links? im new to this. Also instead of making a new thread, when i bought the car there was fog lights on it and there is a switch to turn them on but they dont go on. Any help?

 

what makes a good strut bar is the joint, its best to have no joint at all to allow the least amount of chassis flex, like a Tripod bar or this bar: http://cgi.ebay.com/ebaymotors/jdm-9...ltDomainQ5f100

but because these type are so expensive , I plan on doing something in the middle that does have a joint, but it is a sturdier one than the little thin ebay $10 bars

http://cgi.ebay.com/ebaymotors/STRUT...mZ390078557228

I would not even bother with lower tie bars, everyone I have talked to says they are pretty much pointless

 

I have a ebay strut tower bar. I notice barely any difference so I am planning on replacing it with a 3-point one. You should just save your money and get a better name-brand one.