hey guys.first of all.thxxx for all the help you guys might give me with this question.
my car will not drive.i just replaced the clutch bearing,clutch,flywheel,and the throwout bearing.and the tranny was replaced about 1k miles ago.my car starts perfectly fine.no knocking,chattering or any of that. it goes into gear. but just does not actually transfer power to the wheels.any help??? would be greatly appreciated.by the way car only has 90k miles on it.i also been searching the forums for a while.and havnt been able to find anything related. and yes i used the search link also.

 

get under it and make sure your cv axle are all the way in the trans. make sure there is NO gap.

 

Alright ill check.if there is a gap. I have to just hammer the cv axle in more right? Then tighten the axle bolt with a pressure gun? Thanks for the help

 

just wiggle and tap it in more into the trans... the axle nut should already be tight...

 

any noises?

 

no.when i rev it there isnt any irregular noises or anything like that

 

did you check the cv axles??????????

 

+1 on 94civic's post.
Either its your CV's, or the clutch was installed incorrectly, and has broken.

 

yeah i checked all the stuff and my clutch forks broke.
hella bs,well thxx anyways guys