can anyone take a pic or explain to me which plug is the oil fill on a 4th gen cable tranny...the one i think it is cant be it cuz its just abotu imposible to get to

 

heres what i do and it works everytime for me. remove the reverse switch located at the top of the transmission. find a funnel that fits into the hole, then fill. the fill plug on our trannys are by far the worst engineered IMO.

 

where is the reverse switch?

 

is it the electrical connector that has 2 wires that run somwhere by the dizzy?....u take it off with like a 17mm wrench?

 

more or less below the dizzy. yes it has 2 wires and it is removed with a 19mm wrench.

 

yea i got it...thanks alot...how much would u recomend putting in...i put like 1.5 -2 quarts....shoul;d i add more or?

 

i have always used 2qts

 

There is a fill hole on the bottom part of the tranny I think 17mm if I remember right. The book says to fill until it will drain back out same hole. The problem with that is it's on the side so a regular funnel won't work. It says to use a syringe, or I imagine a flexible small type funnel would work dropped down from the top of the engine. I used a rubber hose duct taped to the funnel. It isn't too bad to get to from under the car. [:@]

 

thats what i use too. or this funnel i got that has a soft hose on the end, that works great too.