Alright, I'm sure this is on here somewhere, but I went through 14 pages in this section, and haven't found an answer yet. Could someone point me in the right direction? I have a 94 Del Sol with a D15 and a 93 hatch with a D16z6 in it. I built the D16 over summer, but now I'm selling the hatch with the D15 in it, and putting the D16 into the Del Sol. Naturally the Del Sol doesn't have a Vtec plug for the solenoid. Will there be wires coming out of the ECU harness to hook up the solenoid? And I'm assuming thats the only part of the harness that will be different, but if anyone knows of any others, the help would be greatly appreciated! Thanks alot for any help!

 

not positive, but u will have to take the hatch ecu out and put it in the del sol, and then add a pin for the vtec, and a pin for the pressor sensor to the harness, and then run the wiring.

 

Alright, I had read that a couple places before, but I wanted to double check before I started the swap. Thanks again!