Need some helpful advice on a D16Y7 swap
#1
Need some helpful advice on a D16Y7 swap
okay, i've done alot of research on this board to find out what i exactly need for this swap. i have some questions that i haven't found answers for.
1. im going from the stock D15 from my CX to a D16Y7, what do i need for the motor to run?
2. i have a D16Y8 head available. i know the head swap wouldn't be hard for a mini-me, but what head gasket should i run (keeping in mind i don't want to raise compression), what Timing belt, etc.
3. what wiring harness/ecu would i need to get this motor to run? i have the Vtec ecu from a Y8 and whole body harness from a 96 EX available. would i need to swap this out completely, or use my stock harness and wire for Vtec?
I'd highly appreciate any answers to these questions because im in the dark, and im running on borrowed time because my D15 is pretty much on the way out. thanks fellas!
1. im going from the stock D15 from my CX to a D16Y7, what do i need for the motor to run?
2. i have a D16Y8 head available. i know the head swap wouldn't be hard for a mini-me, but what head gasket should i run (keeping in mind i don't want to raise compression), what Timing belt, etc.
3. what wiring harness/ecu would i need to get this motor to run? i have the Vtec ecu from a Y8 and whole body harness from a 96 EX available. would i need to swap this out completely, or use my stock harness and wire for Vtec?
I'd highly appreciate any answers to these questions because im in the dark, and im running on borrowed time because my D15 is pretty much on the way out. thanks fellas!
Thread
Thread Starter
Forum
Replies
Last Post
Tinkerbell_too
Inside and Out
2
10-06-2010 08:17 AM
SkItZiAnIsT
Mechanical Problems & Technical Chat
0
11-11-2005 12:25 PM