what should i do next, i have a full exhaust, full headers, intake, short throw, plugs, wires, what would be a good step from here? i know every1 is going to say NOS or boost but i dont want to mess this engine up, what does every1 think about CRYO2 as an alternative, doesnt mess w/ the block as badly as NOS and only runs about 350$ plus a lot cheaper to get refilled

thanks for the input in advance

 

One word...Suspension

 

hey thts the same car i have. i would get some rims and drop it a few. its no preformace upgrade but a set of 17' rims with a drop looks TIGHT
(my car isnt droped though)

 

16's with 205-45/16 tires and Tokico HPK = ftw

 

hey forty no tryn to get off topic but how much would lyk 1/2-1" drop cost???

 

Suspension, brakes, and weight reduction.

In my opinion, the stated mods should be done before you do any HP mods.

Once you do that, get an intake manifold and throttle body. Then get you're head done and do some valvetrain work.

 

Really depends on quality, not the amount of drop. Mine (1.4" front, 1.0" rear) were upwards of $500 for the shocks and struts, but they are an awesome setup