Thats crazy that you all don't get Civics on the yards there. Civics are everywhere here, so of course the junk yards are full of them. The pull-a-part always has at least 3 EKs, like 5 EGs, and even more EFs.

 

This one has seriously, not one civic.

 

Mine always have gutted Civics. Like, the good yard is near the air base and someone has connections. When the cars are finally out on the lot, they're already picked apart and the good stuff is gone. Some of the airmen make some profit on the side.

 

My junkyard doesn't have many civics either, maybe 5? And most are gutted too. Bunch of z6's are always there though, but the people there are dicks on prices.

 

Ok, now that I have time galore and I do not drive my car.............. Anyone have any suggestions for some cheap DIY stuff I should get done?

 

ENGINE BAY SHAVE. At least do a full harness tuck if you don't have a welder. It'll just cost you wire and solder and shrink tubing, and looks baller. I can't wait to shave mine.

 

fix your axle, convert to mpfi,swap 4speed trans to 5speed. drop in a center console. get amber corners.

 

I am not pulling the engine out, I wish I could have shaved it while I was doing swap but my pa was in too much of a hurry to get engine in


You scrub, lol I know all that stuff, all that stuff is just buying parts, I said cheap DIY ish

 

^Don't fret about not being able to tuck (yet). I took me 6 months to complete my project once I jumped into it. It was only possible because I had the support of my family that I was able to get it done.

 

spraypaint black headlight housing? has a good satisfaction to effort ratio.