i wouldn't put it there... my friend put his 12V wire to his amp on his ford focus under the transmission like that and it melted.

 

my wire harnesses are over the top of the transmission... not under and back. lay it with the other wires. just be sure it doesnt touch the exhaust pipes....

 

Which way would you install the mid pipe? mid pipe has two hangers and car has one rubber thing to put it on.






;

 

hhhh.. i take it off the ramp to see if this was the right way and its not.. the second piece of the mid pipe didn't reash the other hanger and the flange was turn to much and it didnt line up.. so i went to drive it up on the ramp to remove it, and the flange hang to low and hit the garage door lip... i was driving slow, i hope i didnt wreck anything.... so i dont no what to do......

When i was reversing the car on the ramps the flange was draging on the ground.

im back to still; fibngering out how to put mid pipe on....

 

maby i have the cat upside down? Do's the shield face up or down? i have the shield facing up.
??

 

now my cat is leaking air... one of the bolts will not tightin and you can move it up and down on the donut gasket.. im going to try the bolts with the springs..

im calling it a night,,ill do this later... hh

 

nvm i for got about the o2 sensor, i don't think that faces down..

 

the sensor goes on the top side.

 

This shouldnt be so difficult. The only system I put on was a breeze. The midpipe should fit right up. If it doesnt look right, its probably not.

 

i think the mid pipe don't line up with the hanger is on the car.......ill try again..i think im going to have to rig it.. the mid pipe has two hangers and that's pissing me off. i think im going to need that cut off, because i think it will drag.... if it dosint work ill try to use them clamps i have on my intake.