possible to modify B16 header to fit GSR head?
#1
possible to modify B16 header to fit GSR head?
I plan on fitting a GSR head to my B16A2 and was wondering if it is possible to modify (perhaps re-drill) a B16 header flange to support GSR fitment? Basicallly, can i modify a B16 header to fit a GSR head?
#2
I believe a b-series header is a b-series header; they're interchangeable to the best of my knowledge.
(and honestly, there's no real point in swapping to the gsr head; the b16a head flows better than the gsr head)
(and honestly, there's no real point in swapping to the gsr head; the b16a head flows better than the gsr head)
#3
B16 head > GSR head
The only difference between a GSR header and a B16 header is the length of the collector. The collector is longer on a GSR then a B16, so therefor the flanges are the same and a B16 header will bolt right to a GSR head and vise versa
The only difference between a GSR header and a B16 header is the length of the collector. The collector is longer on a GSR then a B16, so therefor the flanges are the same and a B16 header will bolt right to a GSR head and vise versa
#4
yep!!!!!
Thread
Thread Starter
Forum
Replies
Last Post