Hello... My speedometer went bad so when I REPLACED the Speedometer I took out my old gauge face and needle. Before I did this swap..When I use to drive on the highway my RPM was at 5 the speedometer would be at 80 mph. Now with the new swap on the highway going at 80 mph the RPM now reads 4 1/4. I think my Speed is behind by 10 mph. Anybody with some help will be greatly apreciated..Anybody out there with a Civic Si 99-00 or with an B16 engine swap PLEASE HELP ME????[&o]

 

ANYBODY??????

 

I dont have a B16 swap but if you pulled the needle off to get the guage face off then i can tell you first hand you pretty much toasted the guage cluster when you removed the needles they just do not work right after that. I did it once and had to replace the cluster

 

I think it's really close now because now going at 80mph the RPM reads about 4 1/2 to 4 3/4. Tomorrow morning I'm going to drive by this street where they have a digital MPH reader. It's there to encourage drivers to slow down just in case you are driving too fast..Yeah that really helps people out...Yeah right.lol.. I will test it there. I'll post my results....[&:]

 

Mine would not read the same as yours as I have only have the Si cluster under the hood I have a GSR motor and trann. so the readings would not be the same sorry bro cant help you there

 

Thanks for all your help but if you know somebody with the same Car and you find out Please PM or repost it. I will appreciate it very much!!!!