forth igintion coil 3 months help!!
#11
where would i find the ground wire. i checked the voltage between the power and ground (going to the ignition coil) and i got 11.55 volts but should't it be the same as the battery voltalge witch is 12.05
the fuel pump is still going and the distribuer is geting power
and i think my coils were ok now
the fuel pump is still going and the distribuer is geting power
and i think my coils were ok now
Last edited by Seamus; 11-01-2008 at 09:13 AM.
#12
When you turn the key to ON(II), does the CEL remain ON or does it turn OFF after two seconds?
If the CEL remains ON, retrieve the CEL code(s) from the ECU as detailed at the link in my signature.
If the CEL turns OFF after two seconds, then perform the input tests described in the diagram below:
If the CEL remains ON, retrieve the CEL code(s) from the ECU as detailed at the link in my signature.
If the CEL turns OFF after two seconds, then perform the input tests described in the diagram below:
Thread
Thread Starter
Forum
Replies
Last Post
captainm619
Mechanical Problems & Technical Chat
1
05-24-2011 04:14 AM
kitty2604
Mechanical Problems & Technical Chat
3
02-17-2010 06:32 AM
Hailchristian
Pics and Videos
6
07-06-2008 07:16 PM