is this intake good?
it has a k&n filter, but i dont know if that matters?
http://cgi.ebay.com/ebaymotors/06-20...spagenameZWDVW
http://cgi.ebay.com/ebaymotors/06-20...spagenameZWDVW
ok thanks, i know everyone says there easy to put on, but i think i have to take off the front bumper, so it cant be that easy, about how long do you think it would take (considering i dont know what the F*** iam doing) ill just be reading instructions.
ORIGINAL: Sigracer10
ya man theres a lot of people on the forum usinginexpensive ebay intakes with either a k&n or aem filter. and since that already comes with the k&n filter, you're good to go.
ya man theres a lot of people on the forum usinginexpensive ebay intakes with either a k&n or aem filter. and since that already comes with the k&n filter, you're good to go.
ORIGINAL: FaCivic06lx
ok thanks, i know everyone says there easy to put on, but i think i have to take off the front bumper, so it cant be that easy, about how long do you think it would take (considering i dont know what the F*** iam doing) ill just be reading instructions.
ok thanks, i know everyone says there easy to put on, but i think i have to take off the front bumper, so it cant be that easy, about how long do you think it would take (considering i dont know what the F*** iam doing) ill just be reading instructions.
my cold air took me about an hour, but that was the second time i had done an intake. i originally had a short ram. so if its your first thing to do, i would say 2-3 hours
haha looks like ebay has finally caught onto the "cheap tube w/ nice filter" setup
yeah man thast perfect though, alot more convenient than two seperate orders, and install it usually a breeze. Might be a little more complicated on new gens but i think you'll be able to manage
yeah man thast perfect though, alot more convenient than two seperate orders, and install it usually a breeze. Might be a little more complicated on new gens but i think you'll be able to manage
Thread
Thread Starter
Forum
Replies
Last Post
edmaxx
Mechanical Problems & Technical Chat
33
Jun 28, 2010 03:27 PM
strtballer98
Header, Intake, & Exhaust
9
May 20, 2007 08:39 PM



